Edge-Core ECS4660-28F Management Manual page 1879

Hide thumbs Also See for ECS4660-28F:

Table of Contents

This command terminates any active sessions for the specified

neighbor, and removes any associated routing information.

have been administratively shut down. Entries with in an Idle (Admin)

state have been disabled by the neighbor shutdown command.

Console(config-router)#neighbor 10.1.1.66 shutdown

Console(config-router)#

This command configures the switch to store updates in the inbound

neighbor soft-

message buffer, and perform soft re-configuration from this buffer for

reconfiguration

specified neighbors when required. Use the no form to disable this feature.

[no] neighbor {ip-address | group-name} soft-reconfiguration

Router Configuration

Use this command to employ soft reconfiguration for a neighbor. A hard

reset clears and rebuilds specified peering sessions and routing tables.

Soft reconfiguration uses stored information to reconfigure and activate

routing tables without clearing existing sessions. It uses stored update

information to allow you to restore a connection or to apply a new BGP

policy without disrupting the network. Note that outbound soft

reconfiguration does not require inbound soft reconfiguration to be

The command is only available when route refresh capability is not

enabled. Route refresh (RFC 2918) allows a router to reset inbound

routing tables dynamically by exchanging route refresh requests with

peers. Route refresh relies on the dynamic exchange of information

with supporting peers. It is advertised through BGP capability

negotiation, and all BGP routers must support this capability.

show ip bgp summary

ip-address – IP address of a neighbor.

group-name – A BGP peer group containing a list of neighboring

routers configured with the

| IP Routing Commands

Border Gateway Protocol (BGPv4)

command display the neighbors which

neighbor peer-group

Chapters

Table of Contents