Edge-Core ECS4660-28F Management Manual page 1564

| CFM Commands
C 45
HAPTER
Defining CFM Structures
Defining CFM Structures
ethernet cfm ais
level
Enable CFM globally on the switch with the
5.
command.
Enable CFM on the local MEPs with the
6.
command.
Enable continuity check operations with the
7.
command.
Enable cross-check operations with the
8.
command.
Other configuration changes may be required for your particular
environment, such as adjusting the interval at which continuity check
messages are sent (page
check operation (page 1586). You can also enable SNMP traps for events
discovered by continuity check messages
messages (page 1587).
This command configures the maintenance level at which Alarm Indication
Signal (AIS) information will be sent within the specified MA. Use the no
form restore the default setting.
S
YNTAX
ethernet cfm ais level level-id md domain-name ma ma-name
no ethernet cfm ais level md domain-name ma ma-name
level-id – Maintenance level at which AIS information will be sent.
(Range: 0-7)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-44
alphanumeric characters)
D S
EFAULT ETTING
Level 0
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The configured AIS level must be higher than the maintenance level of the
domain containing the specified MA.
– 1564 –
ethernet cfm enable
ethernet cfm port-enable
ethernet cfm cc enable
ethernet cfm mep crosscheck
1581), or setting the start-up delay for the cross-
(page 1583) or cross-check