Edge-Core ECS4660-28F Management Manual page 1863

Hide thumbs Also See for ECS4660-28F:

Table of Contents

This command allows the local router to send a default route to a neighbor.

Use the no form to disable this feature.

default-originate

Router Configuration

Console(config-router)#neighbor 10.1.1.64 default-originate

Console(config-router)#

neighbor {ip-address | group-name} default-originate [route-map

no neighbor {ip-address | group-name} default-originate

ip-address – IP address of a neighbor.

group-name – A BGP peer group containing a list of neighboring

routers configured with the

map-name – Name of the route map. The route map can be used to

filter the criteria used for sending the default route to a neighbor.

(Range: 1-80 characters)

This command is used to advertise the local router's default route

(0.0.0.0) to a neighbor. This route can be used by the neighbor to reach

the local router if no other routes are available.

If several neighbors supply a default route to the same partner, the

best one will be elected according to the standard path selection

If a route map is specified, the default route 0.0.0.0 is advertised if the

route map contains a

match ip address

matches an entry in the

Border Gateway Protocol (BGPv4)

neighbor peer-group

clause and there is a route that

prefix-list.

| IP Routing Commands

Chapters

Table of Contents