Edge-Core ECS4660-28F Management Manual page 1306

| ERPS Commands
C 39
HAPTER
Table 154: ERPS Commands(Continued)
Command Function
erps clear Manually clears protection state which has been invoked by a
Forced Switch or Manual Switch command, and the node is
operating under non-revertive mode; or before the WTR or WTB
timer expires when the node is operating in revertive mode
erps forced- Blocks the specified ring port
switch
erps manual- Blocks the specified ring port, in the absence of a failure or an
switch erps forced-switch command
show erps Displays status information for all configured rings, or for a
specified ring
Configuration Guidelines for ERPS
Create an ERPS ring: Create a ring using the
1.
The ring name is used as an index in the G.8032 database.
Configure the east and west interfaces: Each node on the ring connects
2.
to it through two ring ports. Use the
one port connected to the next node in the ring to the east (or
clockwise direction); and then use the
configure another port facing west in the ring.
Configure the RPL owner: Configure one node in the ring as the Ring
3.
Protection Link (RPL) owner using the
switch is configured as the RPL owner, the west ring port is set as being
connected to the RPL. Under normal operations (Idle state), the RPL is
blocked to ensure that a loop cannot form in the ring. If a signal failure
brings down any other link in the ring, the RPL will be unblocked
(Protection state) to ensure proper connectivity among all ring nodes
until the failure is recovered.
Configure ERPS timers: Use the
4.
is used to prevent ring nodes from receiving outdated R-APS messages,
the holdoff-timer command to filter out intermittent link faults, and the
wtr-timer command to verify that the ring has stabilized before
blocking the RPL after recovery from a signal failure.
Configure the ERPS Control VLAN (CVLAN): Use the
5.
command to create the VLAN used to pass R-APS ring maintenance
commands. The CVLAN must NOT be configured with an IP address. In
addition, only ring ports may be added to the CVLAN (prior to
configuring the VLAN as a CVLAN). No other ports can be members of
this VLAN (once set as a CVLAN). Also, the ring ports of the CVLAN
must be tagged. Failure to observe these restrictions can result in a
loop in the network.
Enable ERPS: Before enabling a ring as described in the next step, first
6.
use the erps command to globally enable ERPS on the switch. If ERPS
has not yet been enabled or has been disabled with the
command, no ERPS rings will work.
– 1306 –
erps domain
ring-port command to configure
ring-port command again to
rpl owner command. When this
guard-timer command to set the timer
control-vlan
Mode
PE
PE
PE
PE
command.
no erps