Edge-Core ECS4660-28F Management Manual page 1872

| IP Routing Commands
C 51
HAPTER
Border Gateway Protocol (BGPv4)
neighbor
peer-group
(Group Members)
neighbor port
This command assigns routers to a peer group. Use the no form to remove
a group member.
S
YNTAX
[no] neighbor ip-address peer-group group-name
ip-address – IP address of a neighbor.
group-name – A BGP peer group.
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
No group members are defined.
C U
OMMAND SAGE
To create a peer group, use the
command.
E
XAMPLE
Console(config-router)#neighbor 10.1.1.64 peer-group RD
Console(config-router)#
This command specifies the TCP port number of the partner through which
communications are carried. Use the no form to restore the default setting.
S
YNTAX
neighbor ip-address port port-number
no neighbor ip-address port
ip-address – IP address of a neighbor.
port-number – TCP port number to use for BGP communications.
(Range: 0-65535)
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
179
E
XAMPLE
Console(config-router)#neighbor 10.1.1.64 port 1023
Console(config-router)#
– 1872 –
neighbor group-name peer-group