Edge-Core ECS4660-28F Management Manual page 1324

| ERPS Commands
C 39
HAPTER
rpl owner
of the RPL. If the switch is set as the RPL neighbor for an ERPS domain,
the east ring port is set as the other end of the RPL.
The east and west connections to the ring must be specified for all ring
◆
nodes using the ring-port
the RPL neighbor, the east ring port is set as being connected to the
RPL.
Note that is not mandatory to declare a RPL neighbor.
◆
E
XAMPLE
Console(config-erps)#rpl neighbor
Console(config-erps)#
This command configures a ring node to be the Ring Protection Link (RPL)
owner. Use the no form to restore the default setting.
S
YNTAX
rpl owner
no rpl
D S
EFAULT ETTING
None (that is, neither owner nor neighbor)
C M
OMMAND ODE
ERPS Configuration
C U
OMMAND SAGE
Only one RPL owner can be configured on a ring. The owner blocks
◆
traffic on the RPL during Idle state, and unblocks it during Protection
state (that is, when a signal fault is detected on the ring or the
protection state is enabled with the
switch command).
The east and west connections to the ring must be specified for all ring
◆
nodes using the ring-port
the RPL owner, the west ring port is automatically set as being
connected to the RPL.
E
XAMPLE
Console(config-erps)#rpl owner
Console(config-erps)#
– 1324 –
command. When this switch is configured as
erps forced-switch
command. When this switch is configured as
or erps manual-