Table of Contents
Advertisement
the connections to the destination network are relatively stable, the hop
count can be restricted to force traffic to follow an alternate path. This
method may be used to avoid less heavily congested paths or to route
traffic through a preferred provider.
E
XAMPLE
Console(config)#route-map RD permit 18
Console(config-route-map)#match peer 192.168.0.99
Console(config-route-map)#set pathlimit ttl 255
Console(config-route-map)#
This command sets the weight for routing messages. Use the no form to
set weight
remove this entry from a route map.
S
YNTAX
C
OMMAND
Route Map
C
OMMAND
◆
◆
E
XAMPLE
Console(config)#route-map RD permit 19
Console(config-route-map)#match peer 192.168.0.99
Console(config-route-map)#set weight 255
Console(config-route-map)#
This command shows the configuration setting for a route map.
show route-map
S
YNTAX
C
OMMAND
Privileged Exec
set weight weight
no set weight
weight – The weight assigned to this route. (Range: 0-4294967295)
M
ODE
U
SAGE
Weights are used to determine the best path available to the local
switch. The route with the highest weight gets preference over other
routes to the same network.
Weights assigned using this command override those assigned by the
neighbor weight
command.
show route-map [map-name]
map-name – Name for the route map. (Range: 1-128 case-sensitive
alphanumeric characters)
M
ODE
– 1917 –
| IP Routing Commands
C
51
HAPTER
Policy-based Routing for BGP
Advertisement
Chapters
Table of Contents
