Table of Contents
Advertisement
This command specifies the interface to use for a TCP connection, instead
neighbor
of using the nearest interface. Use the no form to use the default interface.
update-source
S
YNTAX
C
OMMAND
Router Configuration
D
EFAULT
The nearest (best/closest) interface is used.
C
OMMAND
By default the nearest interface to the neighbor is used for BGP
connections. This command can be used to specify any available interface
for a TCP connection.
E
XAMPLE
Console(config-router)#neighbor 10.1.1.66 update-source interface vlan 1
Console(config-router)#
This command assigns a weight to routes sent from a neighbor. Use the no
neighbor weight
form to restore the default weight.
S
YNTAX
C
OMMAND
Router Configuration
D
EFAULT
Routes learned from a neighbor: 0
Static routes sourced by the local router: 32768
[no] neighbor {ip-address | group-name} update-source interface
vlan vlan-id
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring
routers configured with the
vlan-id - VLAN ID. (Range: 1-4094)
M
ODE
S
ETTING
U
SAGE
neighbor {ip-address | group-name} weight weight
no neighbor {ip-address | group-name} weight
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring
routers configured with the
weight – The weight to be assigned to routes received from this
neighbor. (Range: 0-65535)
M
ODE
S
ETTING
– 1883 –
| IP Routing Commands
C
51
HAPTER
Border Gateway Protocol (BGPv4)
neighbor peer-group
command.
neighbor peer-group
command.
Advertisement
Chapters
Table of Contents
