Edge-Core ECS4660-28F Management Manual page 1858

| IP Routing Commands
C 51
HAPTER
Border Gateway Protocol (BGPv4)
distance bgp
This command sets the administrative distance for external BGP, internal
BGP, and local routes. Use the no form to restore the default settings.
S
YNTAX
distance bgp ebgp-distance ibgp-distance local-distance
no distance bgp
ebgp-distance – Administrative distance for eBGP routes.
(Range: 1-255)
ibgp-distance – Administrative distance for iBGP routes.
(Range: 1-255)
local-distance – Administrative distance for local routes.
(Range: 1-255)
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
eBGP: 20
iBGP: 200
local: 200
C U
OMMAND SAGE
External routes are learned from an external autonomous system, and
◆
internal routes from a peer within the local autonomous system. Local
routes are those configured with the
for the router or for the networks being redistributed from another
routing process.
The route distance indicates the trustworthiness of a router. The higher
◆
the distance the lower the trust rating. A distance of 255 means that
the routing source cannot be trusted and should be ignored.
This command can be used to indicate that another protocol can
◆
provide a better route to a node than that learned via eBGP, or to
indicate that some internal routes should be preferred by BGP.
Changing the administrative distance of iBGP routes is not
◆
recommended. It may cause an accumulation of routing table
inconsistencies which can break routing to many parts of the network.
E
XAMPLE
Console(config-router)#distance bgp 20 200 20
Console(config-router)#
R C
ELATED OMMANDS
distance (1857)
– 1858 –
network command as a back door