Table 252: Open Shortest Path First Commands - Edge-Core ECS4660-28F Management Manual

| IP Routing Commands
C 51
HAPTER
Open Shortest Path First (OSPFv2)
O S P
PEN HORTEST ATH
F (OSPF 2)
IRST V
.

Table 252: Open Shortest Path First Commands

Command Function
General Configuration
router ospf Enables or disables OSPFv2
compatible rfc1583 Calculates summary route costs using RFC 1583 (early
OSPFv2)
default-information Generates a default external route into an autonomous
originate system
router-id Sets the router ID for this device
timers spf Configures the delay after a topology change and the
hold time between consecutive SPF calculations
clear ip ospf process Clears and restarts the OSPF routing process
Route Metrics and Summaries
area default-cost Sets the cost for a default summary route sent into a
stub or NSSA
area range Summarizes routes advertised by an ABR
auto-cost reference- Calculates default metrics for an interface based on
bandwidth bandwidth
default-metric Sets the default metric for external routes imported
from other protocols
redistribute Redistribute routes from one routing domain to
another
summary-address Summarizes routes advertised by an ASBR
Area Configuration
area nssa Defines a not-so-stubby that can import external
routes
area stub Defines a stubby area that cannot send or receive LSAs RC
area virtual-link Defines a virtual link from an area border routers to
the backbone
network area Assigns specified interface to an area
Interface Configuration
ip ospf authentication Specifies the authentication type for an interface
ip ospf authentication-key Assigns a simple password to be used by neighboring
routers
ip ospf cost Specifies the cost of sending a packet on an interface IC
ip ospf dead-interval Sets the interval at which hello packets are not seen
before neighbors declare the router down
ip ospf hello-interval Specifies the interval between sending hello packets
ip ospf Enables MD5 authentication and sets the key for an
message-digest-key interface
ip ospf priority Sets the router priority used to determine the
designated router
– 1750 –
Mode
GC
RC
RC
RC
RC
PE
RC
RC
RC
RC
RC
RC
RC
RC
RC
IC
IC
IC
IC
IC
IC