Table 159: Vlan Commands - Edge-Core ECS4660-28F Management Manual

40
VLAN C
OMMANDS
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic VLAN
registration for the selected interface.

Table 159: VLAN Commands

Command Group Function
GVRP and Bridge Configures GVRP settings that permit automatic VLAN learning;
Extension Commands shows the configuration for bridge extension MIB
Editing VLAN Groups Sets up VLAN groups, including name, VID and state
Configuring VLAN Configures VLAN interface parameters, including ingress and
Interfaces egress tagging mode, ingress filtering, PVID, and GVRP
Displaying VLAN Displays VLAN groups, status, port members, and MAC addresses
Information
Configuring IEEE 802.1Q Configures 802.1Q Tunneling (QinQ Tunneling)
Tunneling
Configuring L2CP Configures Layer 2 Control Protocol (L2CP) tunneling, either by
discarding, processing, or transparently passing control packets
Tunneling *
across a QinQ tunnel
Configuring VLAN Maps VLAN ID between customer and service provider for
networks that do not support IEEE 802.1Q tunneling
Translation *
Configuring Private Configures private VLANs, including uplink and downlink ports
VLANs
Configuring Protocol- Configures protocol-based VLANs based on frame type and
based VLANs protocol
Configuring IP Subnet Configures IP Subnet-based VLANs
VLANs
Configuring MAC Based Configures MAC-based VLANs
VLANs
Configuring Voice VLANs Configures VoIP traffic detection and enables a Voice VLAN
* These functions are not compatible.
– 1337 –