Edge-Core ECS4660-28F Management Manual page 1327

Hide thumbs Also See for ECS4660-28F:

Table of Contents

This command manually clears the protection state which has been

invoked by a forced switch or manual switch command, and the node is

operating under non-revertive mode; or before the WTR or WTB timer

expires when the node is operating in revertive mode.

Privileged Exec

This command blocks the specified ring port.

erps forced-switch

Privileged Exec

erps clear domain ring-name

ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)

Two steps are required to make a ring operating in non-revertive mode

return to Idle state from forced switch or manual switch state:

Issue an erps clear command to remove the forced switch

command on the node where a local forced switch command is

Issue an erps clear command on the RPL owner node to trigger the

The erps clear command will also stop the WTR and WTB delay timers

and reset their values.

More detailed information about using this command for non-revertive

mode is included under the Command Usage section for the

Console#erps clear domain r&d

erps forced-switch [domain ring-name] {east | west}

ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)

east - East ring port.

west - West ring port.

| ERPS Commands

Chapters

Table of Contents