Table of Contents
Advertisement
as an RSPAN source or destination port. Also, when a port is configured
as an RSPAN uplink port, port security cannot be enabled on that port.
Use this command to specify the source port and traffic type to be mirrored
rspan source
remotely. Use the no form to disable RSPAN on the specified port, or with a
traffic type keyword to disable mirroring for the specified type.
S
YNTAX
[no] rspan session session-id source interface interface-list
D
EFAULT
Both TX and RX traffic is mirrored
C
OMMAND
Global Configuration
C
OMMAND
One or more source ports can be assigned to the same RSPAN session,
◆
either on the same switch or on different switches.
Only ports can be configured as an RSPAN source – static and dynamic
◆
trunks are not allowed.
The source port and destination port cannot be configured on the same
◆
switch.
[rx | tx | both]
session-id – A number identifying this RSPAN session. (Range: 1-2)
Only two mirror sessions are allowed, including both local and
remote mirroring. If local mirroring is enabled with the
command, then there is only one session available for RSPAN.
interface-list – One or more source ports. Use a hyphen to indicate
a consecutive list of ports or a comma between non-consecutive
ports.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
rx - Mirror received packets.
tx - Mirror transmitted packets.
both - Mirror both received and transmitted packets.
S
ETTING
M
ODE
U
SAGE
– 1233 –
| Port Mirroring Commands
C
33
HAPTER
RSPAN Mirroring Commands
port monitor
Advertisement
Chapters
Table of Contents
