Table 106: Secure Shell Commands - Edge-Core ECS4660-28F Management Manual

show ip telnet
S S
ECURE HELL
This command displays the configuration settings for the Telnet server.
C M
OMMAND ODE
Normal Exec, Privileged Exec
E
XAMPLE
Console#show ip telnet
IP Telnet Configuration:
Telnet Status: Enabled
Telnet Service Port: 23
Telnet Max Session: 4
Console#
This section describes the commands used to configure the SSH server.
Note that you also need to install a SSH client on the management station
when using this protocol to configure the switch.
The switch supports both SSH Version 1.5 and 2.0 clients.
N :
OTE

Table 106: Secure Shell Commands

Command Function
ip ssh authentication- Specifies the number of retries allowed by a client
retries
ip ssh server Enables the SSH server on the switch
ip ssh server-key size Sets the SSH server key size
ip ssh timeout Specifies the authentication timeout for the SSH
server
copy tftp public-key Copies the user's public key from a TFTP server to the
switch
delete public-key Deletes the public key for the specified user
disconnect Terminates a line connection
ip ssh crypto host-key Generates the host key
generate
ip ssh crypto zeroize Clear the host key from RAM
ip ssh save host-key Saves the host key from RAM to flash memory
show ip ssh Displays the status of the SSH server and the
configured values for authentication timeout and
retries
show public-key Shows the public key for the specified user or for the
host
– 1057 –
| Authentication Commands
C 28
HAPTER
Secure Shell
Mode
GC
GC
GC
GC
PE
PE
PE
PE
PE
PE
PE
PE