| Interface Commands
C
31
HAPTER
Transceiver Threshold Configuration
transceiver-
threshold voltage
Low Warning: -21.00 dBm
Low Alarm: -21.50 dBm
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
C
U
OMMAND
SAGE
The threshold value is the power ratio in decibels (dB) of the measured
◆
power referenced to one milliwatt (mW).
Refer to the Command Usage section under the
◆
current
command for more information on configuring transceiver
thresholds.
Trap messages enabled by the
◆
are sent to any management station configured by the
host
command.
E
XAMPLE
The following example sets alarm thresholds for the signal power
transmitted at port 1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold tx-power low-alarm 8
Console(config-if)#transceiver-threshold tx-power high-alarm -3
Console#
This command sets thresholds for the transceiver voltage which can be
used to trigger an alarm or warning message.
S
YNTAX
transceiver-threshold voltage {high-alarm | high-warning | low-
alarm | low-warning} threshold-value
high-alarm – Sets the high voltage threshold for an alarm
message.
high-warning – Sets the high voltage threshold for a warning
message.
low-alarm – Sets the low voltage threshold for an alarm message.
low-warning – Sets the low voltage threshold for a warning
message.
threshold-value – The threshold of the transceiver voltage.
(Range: 100-25500 in units of 0.01 Volt)
D
S
EFAULT
ETTING
High Alarm: 3.50 Volts
HIgh Warning: 3.45 Volts
Low Warning: 3.15 Volts
Low Alarm: 3.10 Volts
– 1210 –
transceiver-threshold
transceiver-threshold-monitor
command
snmp-server