Edge-Core ECS4660-28F Management Manual page 990

Hide thumbs Also See for ECS4660-28F:

Table of Contents

| System Management Commands

Switch Clustering

cluster commander

This command enables clustering on the switch. Use the no form to disable

[no] cluster

Global Configuration

To create a switch cluster, first be sure that clustering is enabled on the

switch (the default is enabled), then set the switch as a Cluster

Commander. Set a Cluster IP Pool that does not conflict with any other

IP subnets in the network. Cluster IP addresses are assigned to

switches when they become Members and are used for communication

between Member switches and the Commander.

Switch clusters are limited to the same Ethernet broadcast domain.

There can be up to 100 candidates and 16 member switches in one

A switch can only be a Member of one cluster.

Configured switch clusters are maintained across power resets and

network changes.

Console(config)#cluster

Console(config)#

This command enables the switch as a cluster Commander. Use the no

form to disable the switch as cluster Commander.

[no] cluster commander

Global Configuration

Chapters

Table of Contents