Mazda CX-9 Grand Touring 2009 Manual page 90

2008 RESTRAINTS Symptom Troubleshooting (Restraints) - Mazda CX-9
Inspect the DTC for the SAS control module on-
board diagnostic system.
4
Have DTCs been recorded in memory?
INSPECT DTCS IN INSTRUMENT CLUSTER
Inspect the DTC for the instrument cluster on-
5
board diagnostic system.
Have DTCs been recorded in memory?
INSPECT INSTRUMENT CLUSTER
Inspect the instrument cluster warning lights
using check code.
6
(See INSTRUMENT CLUSTER
INPUT/OUTPUT CHECK MODE .)
Are the check results okay?
INSPECT POWER SUPPLY CIRCUIT OF SAS
CONTROL MODULE (TERMINAL 1D)
Turn the ignition switch to LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Connect all SAS control module connectors.
Connect the driver and passenger-side pre-
tensioner seat belt connectors.
7 Connect the driver and passenger-side curtain air
bag module connectors. Connect the driver and
passenger-side front seat connectors.
Connect the passenger-side air bag module
connector.
Connect the clock spring connector.
Inspect the voltage for PID/DATA monitor
IGN_V_2 item using M-MDS.
Is the voltage of at least one terminal 8 V - 16
V ?
INSPECT WIRING HARNESS BETWEEN
BATTERY AND FUSE BLOCK
8
Connect the negative battery cable.
Turn the ignition switch to ON position.
Measure the voltage at instrument cluster
2008 Mazda CX-9 Grand Touring
Perform the applicable DTC
Yes inspection, then go to Step 10. (See
DTC TABLE .)
No Go to the next step.
Perform the applicable DTC
inspection, then go to Step 10. (See
Yes
CLEARING DTC [INSTRUMENT
CLUSTER] .)
No Go to the next step.
Yes Go to the next step.
Repair or replace the instrument
No cluster according to inspection results.
Then go to Step 10.
Yes Go to the Step 9.
No Go to the next step.
Yes Go to the next step.
No
Repair the wiring harnesses, then go to