Mazda CX-9 Grand Touring 2009 Manual page 486

(See FRONT ABS WHEEL-
SPEED SENSOR INSPECTION .)
(See REAR ABS WHEEL-SPEED
SENSOR INSPECTION [2WD] .)
(See REAR ABS WHEEL-SPEED
SENSOR INSPECTION [AWD] .)
Is the clearance normal?
2
Clearance
Front: 0.7-1.5 mm {0.028-0.059 in}
Rear (2WD): 0.3-1.1 mm {0.012-
0.043 in}
Rear (AWD): 0.95-1.75 mm {0.038-
0.068 in}
VISUALLY INSPECT ABS SENSOR
ROTOR FOR FOREIGN MATERIAL
ADHERING OR IMPROPER
3
INSTALLATION
Is the result normal?
VERIFY THAT THE SAME DTC IS
NOT PRESENT
Clear the DTC from the memory.
(See ON-BOARD DIAGNOSTIC
4
[DSC/RSC].)
Start the engine and drive the vehicle
at 10 km/h {6.2 mph} or more.
Are the same DTCs present?
VERIFY THAT NO OTHER DTCS
ARE PRESENT
5
Are any other DTCs output?
2008 Mazda CX-9 Grand Touring
2008 BRAKES On-Board Diagnostic (DSC/RSC) - Mazda CX-9
Replace the ABS wheel-speed sensor, then go to
(See FRONT ABS WHEEL-SPEED SENSOR
REMOVAL/INSTALLATION .)
No
(See REAR ABS WHEEL-SPEED SENSOR
REMOVAL/INSTALLATION [2WD] .)
(See REAR ABS WHEEL-SPEED SENSOR
REMOVAL/INSTALLATION [AWD] .)
Yes Go to the next step.
Replace the front drive shaft, rear wheel hub
component (2WD) or rear drive shaft (AWD),
then go to the next step.
(See FRONT DRIVE SHAFT
No REMOVAL/INSTALLATION .)
(See WHEEL HUB COMPONENT
REMOVAL/INSTALLATION [2WD] .)
(See REAR DRIVE SHAFT
REMOVAL/INSTALLATION .)
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC/RSC
Yes HU/CM, then go to the next step.
(See DSC/RSC HU/CM
REMOVAL/INSTALLATION .)
No Go to the next step.
Go to the applicable DTC inspection.
Yes
(See ON-BOARD DIAGNOSTIC [DSC/RSC].)
No DTC troubleshooting completed.
Step 4.