Mazda CX-9 Grand Touring 2009 Manual page 24

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
INSPECT WIRING HARNESS BETWEEN
DRIVER-SIDE SIDE AIR BAG MODULE AND
SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
Remove the glove compartment. (See GLOVE
COMPARTMENT
REMOVAL/INSTALLATION .)
Disconnect the passenger-side air bag module
connector. (See PASSENGER-SIDE AIR
BAG MODULE
REMOVAL/INSTALLATION .)
Disconnect the passenger-side front seat
connector. (See FRONT SEAT
4
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side
curtain air bag module connectors. (See
CURTAIN AIR BAG MODULE
REMOVAL/INSTALLATION .)
Remove the B-pillar lower trim. (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See FRONT
SEAT BELT
REMOVAL/INSTALLATION .)
Disconnect the SAS control module connectors.
(See SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
Inspect the wiring harness between SAS control
module terminal 2F and driver-side side air bag
module terminal A, SAS control module
terminal 2B and driver-side side air bag module
terminal B for the following:
Short to ground
Short to power supply
2008 Mazda CX-9 Grand Touring
Replace the SAS control module. (See
Yes SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
No Replace the air bag wiring harness.