Mazda CX-9 Grand Touring 2009 Manual page 362

2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
[MZI-3.7] .)
3. Remove the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
4. Verify that there is no continuity between coupler component terminals B1, B3, B4, B9, B10, B11, B14,
B17, B18, B21, B22 and GND.
If there is any malfunction, inspect the coupler component.
If the coupler component is normal, replace the control valve body. (See CONTROL VALVE
BODY REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
5. Install the TCM. (See TCM REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
6. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-
3.7] .)
7. Connect the negative battery cable.
TCM INSPECTION [AW6A-EL, AW6AX-EL]
TR SWITCH OPERATING INSPECTION
1. Verify that the starter operates only when the ignition switch is turned to the START position with the
selector lever in P or N position.
If there is any malfunction, neutral position learning. (See TCM REMOVAL/INSTALLATION
[AW6A-EL, AW6AX-EL].)
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch at the ON
position.
If there is any malfunction, neutral position learning. (See TCM REMOVAL/INSTALLATION
[AW6A-EL, AW6AX-EL].)
3. Verify that the positions of the selector lever and the indicator light correspond.
If there is any malfunction, perform the neutral position learning. (See TCM
REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
4. Verify that the TR PID is normal.
If there is any malfunction, perform the neutral position learning. (See TCM
REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL].)
2008 Mazda CX-9 Grand Touring