Mazda CX-9 Grand Touring 2009 Manual page 704

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
Fig. 11: Identifying Master Cylinder (Primary Side & Secondary Side)
Courtesy of MAZDA MOTORS CORP.
DSC/RSC HU/CM CONNECTOR INSTALLATION NOTE
1. Install the DSC/RSC HU/CM connector using the following procedure:
1. After verifying that the lock lever is locked by the lower tab, connect the DSC/RSC HU/CM
connector to the DSC/RSC HU/CM.
2. Pull up the lock lever by pressing the lower tab, and release the lock.
3. Pull up the lock lever and lock it using the upper tab.
2. Verify that the DSC/RSC HU/CM connector is installed securely.
Fig. 12: View Of DSC/RSC HU/CM Connector
Courtesy of MAZDA MOTORS CORP.
DSC/RSC HU AIR BLEEDING
1. Turn the ignition switch off.
2. Connect the M-MDS to the DLC-2.
3. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
When using the IDS (laptop PC)
1. Select "Chassis".
2. Select "Braking".
2008 Mazda CX-9 Grand Touring