2005-08 TRANSMISSION Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6
Fig. 187: Placing SST On Clutch Balancer
Courtesy of MAZDA MOTORS CORP.
8. Install the snap ring into the groove using snap ring pliers.
9. Install the driven plates, drive plates and the retaining plate in the following order to the intermediate
shaft as shown in the figure.
Three drive plates type
Driven- Drive- Driven- Drive- Driven- Drive- Retaining
Four drive plates type
Driven- Drive- Driven- Drive- Driven- Drive- Driven- Drive- Retaining
Fig. 188: Identifying Driven Plates, Drive Plates And Retaining Plate
Courtesy of MAZDA MOTORS CORP.
CAUTION:
2008 Mazda CX-9 Grand Touring
Inspect the number and order of the retaining plate, drive and
driven plates.