2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
1. Select "DataLogger".
2. Select "Modules".
3. Select "ABS".
When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "ABS".
3. Select "DataLogger".
Fig. 35: Connecting M-MDS To DLC-2
Courtesy of MAZDA MOTORS CORP.
8. Select the "MCYLIP" PID.
9. Start the engine.
10. Depress the brake pedal, and confirm that the fluid pressure value of the SST (Gauge) and the value
shown on the M-MDS are equal
If the fluid pressures are different, replace the DSC/RSC HU/CM. (See DSC/RSC HU/CM
REMOVAL/INSTALLATION.)
11. After the inspection, remove the SSTs, install the brake hose, clamp, and brake pipe to the original
positions, and then bleed the air from the brake line.
2008 Mazda CX-9 Grand Touring