Mazda CX-9 Grand Touring 2009 Manual page 714

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
Fig. 20: Identifying Rear ABS Wheel Speed Sensor Connector, Rear ABS Wheel Speed Sensor, Bolt
& Torque Specifications
Courtesy of MAZDA MOTORS CORP.
8. Install in the reverse order of removal.
REAR ABS WHEEL-SPEED SENSOR INSPECTION [2WD]
INSTALLATION VISUAL INSPECTION
1. Inspect the following items:
If there is any malfunction, replace the applicable part.
1. Excessive play of the ABS wheel-speed sensor
2. Deformation of the ABS wheel-speed sensor
CLEARANCE INSPECTION
1. Remove the rear ABS wheel-speed sensor.
2. Measure the distance between the rear ABS wheel-speed sensor installation surface and the ABS sensor
rotor. This is dimension A.
3. Calculate the clearance between the front ABS wheel-speed sensor and the ABS sensor rotor using the
following formula:
Clearance (mm {in}) = A-15.0 {0.60 in}
4. Verify that the clearance between the ABS sensor rotor and the rear ABS wheel-speed sensor is as
indicated below.
If there is any malfunction, replace it.
Clearance
0.3-1.1 mm {0.012-0.043 in}
Fig. 21: Identifying Distance Between Rear ABS Wheel-Speed Sensor & ABS Sensor Rotor
2008 Mazda CX-9 Grand Touring