Mazda CX-9 Grand Touring 2009 Manual page 43

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
terminals A and B.
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
3 Connect the negative battery cable.
Turn the ignition switch to the ON position.
Are DTCs B1054, B1877, B1878, B1879,
and/or B1885 indicated?
INSPECT WIRING HARNESS BETWEEN
DRIVER-SIDE PRE-TENSIONER SEAT BELT
AND SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
Remove the glove compartment. (See GLOVE
COMPARTMENT
REMOVAL/INSTALLATION .)
Disconnect the passenger-side air bag module
connector. (See PASSENGER-SIDE AIR
BAG MODULE
4
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side front
seat connectors. (See FRONT SEAT
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side curtain
air bag module connectors. (See CURTAIN
AIR BAG MODULE
REMOVAL/INSTALLATION .)
Remove the B-pillar lower trim. (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See FRONT
SEAT BELT
REMOVAL/INSTALLATION .)
Disconnect the SAS control module connectors.
(See SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
Replace the driver-side pre-tensioner
seat belt.
No
(See FRONT SEAT BELT
REMOVAL/INSTALLATION .)
Replace the SAS control module. (See
Yes SAS CONTROL MODULE
REMOVAL/INSTALLATION .)