Mazda CX-9 Grand Touring 2009 Manual page 589

1. Remove the ATF oil cooler pipe with the hoses still connected. Position the ATF oil cooler pipe so that it
is out of the way.
COOLING FAN COMPONENT REMOVAL NOTE
1. Remove the cooling fan component from above the engine compartment.
FAN MOTOR INSPECTION [MZI-3.7]
PART INSPECTION
1. Verify that the battery is fully charged. (See BATTERY INSPECTION [MZI-3.7] .)
2. Disconnect the cooling fan motor connector (fan control module side, 2 terminals).
3. Install a tester and battery to the cooling fan motor connector as shown in the figure.
4. Verify that each fan motors operate smoothly at the standard current.
If there is any malfunction, replace the applicable part.
Cooling fan motor standard current [Single Fan Control Module]
No.1, No.2: 11.2-15.2 A
Cooling fan motor standard current [Dual Fan Control Module]
No.1, No.2: 17-23 A
Fig. 24: Identifying Cooling Fan Motor Connector
Courtesy of MAZDA MOTORS CORP.
FAN CONTROL MODULE INSPECTION [MZI-3.7]
2008 Mazda CX-9 Grand Touring
2008 ENGINE Cooling System (MZI-3.7) - Mazda CX-9