Mazda CX-9 Grand Touring 2009 Manual page 16

curtain air bag
module resistance)
RES_PT_D
(Driver-side pre-
tensioner seat belt
resistance)
RES_PT_P
(Passenger-side
pre-tensioner seat
belt resistance)
RES_SAB_D
(Driver-side side
air bag module
resistance)
RES_SAB_P
Passenger-side side
air bag module
resistance)
TRAK_SW Seat
track position
sensor state)
(1) Used during seat weight sensor calibration setting. Not necessary for diagnostic.
(2) When the calibration error is displayed, the error can be cleared by turning the ignition switch to the
LOCK position.
DTC B1013
DTC B1013 DETECTION CONDITION AND POSSIBLE CAUSE
DTC B1013 Seat weight sensor calibration error
WARNING:
DETECTION
CONDITION
POSSIBLE
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
ohm
ohm
ohm
ohm
Forward/Rearward
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an inspection according to only the
detection conditions may cause injury due to an operating error, or damage
the system. When performing an inspection, always follow the inspection
procedure.
Calibration set value not within valid range.
Weight acting on front passenger-side seat during calibration
Improperly installed front passenger-side seat part at time of calibration
Deformed floor where attached to front passenger-side seat
Deformed front passenger-side seat under-bracket or frame
1.0-9.7 ohms
Under any condition:
1.0-9.7 ohms
Under any condition:
1.0-9.7 ohms
Under any condition:
1.0-9.7 ohms
Under any condition:
1.0-9.7 ohms
Front seat front
position: Forward
Front seat rear
position:
Rearward
2AL
2N, 2J
2A, 2E
2B, 2F
21, 2M
2AB,
2AF