Mazda CX-9 Grand Touring 2009 Manual page 474

(See ON-BOARD DIAGNOSTIC
[DSC/RSC].)
2
Are the same DTCs present?
VERIFY AFTER REPAIR
PROCEDURE.
3
Are any other DTCs present?
DTC C1095, C1096 [DSC/RSC]
DTC C1095, C1096 [DSC/RSC] DETECTION CONDITION AND POSSIBLE CAUSE
DTC C1095, C1096 Pump motor, motor relay system
DETECTION
CONDITION
POSSIBLE CAUSE
2008 Mazda CX-9 Grand Touring
2008 BRAKES On-Board Diagnostic (DSC/RSC) - Mazda CX-9
No
Yes
No
C1095
ABS motor monitor OFF signal is input within specified time limit when the
motor signal is switched from ON to OFF by DSC/RSC HU/CM.
C1096
When pump motor monitor voltage continues for 0.05s more than 0.75V
among the pump motor ON.
ABS 50A fuse malfunction
Open or short to ground circuit in the wiring harness between the battery and the
DSC/RSC HU/CM terminal AK
Open circuit in the wiring harness between the DSC/RSC HU/CM terminal B and
the body ground
Open or short circuit in the DSC/RSC HU/CM internal motor relay, or stuck motor
relay
Open or short circuit in the DSC/RSC HU/CM internal motor, or frozen motor
Motor relay malfunction
Poor connection at connectors (female terminal)
(See DSC/RSC HU/CM
REMOVAL/INSTALLATION .)
Go to the next step.
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC [DSC/RSC].)
DTC troubleshooting completed.