Mazda CX-9 Grand Touring 2009 Manual page 513

GENERAL PROCEDURES(BRAKE)
WHEEL AND TIRE INSTALLATION
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following
tightening torque.
Tightening torque
107.8-147.0 N.m {11.0-14.9 Kgf.m, 79.6-108.4 ft.lbf}
Fig. 1: Identifying Wheel And Tire Nuts Tighten Sequence
Courtesy of MAZDA MOTORS CORP.
BRAKE LINES DISCONNECTION
1. If any brake line has been disconnected during the procedures, add brake fluid, bleed the brakes, and
inspect for leakage after the procedure has been completed.
CAUTION:
BRAKE PIPE FLARE NUT TIGHTENING
1. Tighten the brake pipe flare nut using the commercially available flare nut wrench.
CONNECTOR DISCONNECTION
1. Disconnect the negative battery cable before performing any work that requires handling of connectors.
(See BATTERY REMOVAL/INSTALLATION [MZI-3.7] .)
2008 Mazda CX-9 Grand Touring 2008 Mazda CX-9 Grand Touring
2008 BRAKES General Procedures (Brakes) - Mazda CX-9 2008 BRAKES General Procedures (Brakes) - Mazda CX-9
2008 BRAKES
General Procedures (Brakes) - Mazda CX-9
Brake fluid will damage painted surfaces. Be careful not to spill
any on painted surfaces. If it is spilled, wipe it off immediately.