Mazda CX-9 Grand Touring 2009 Manual page 872

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
2. Select "OBD Test Modes".
3. Select "Mode 1 Powertrain Data".
4. Select "PCM".
When using the PDS (Pocket PC)
1. Select "OBDII Modes".
2. Select "Mode 1 Powertrain Data".
3. Select "PCM".
Fig. 8: Identifying DLC-2
Courtesy of MAZDA MOTORS CORP.
3. Then, select the "***SUP" and "**EVAL" PIDs in the PID selection screen.
4. Monitor those PIDs and check it system monitor is completed.
NOTE:
PID/DATA MONITOR AND RECORD PROCEDURE
NOTE:
The PID/DATA MONITOR function monitors the calculated value of the
input/output signals in the PCM. Therefore, an output device malfunction
is not directly indicated as a malfunction of the monitored value for the
output device. If a monitored value of an output device is out of
specification, inspect the monitored value of the input device related to the
output control.
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
When using the IDS (laptop PC)
1. Select "DataLogger".
2. Select "Modules".
3. Select "PCM".
2008 Mazda CX-9 Grand Touring
If the on-board system readiness tests are not completed the PCM
stores DTC P1000.