Mazda CX-9 Grand Touring 2009 Manual page 461

ACTIVE COMMAND MODES PROCEDURE
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
When using the IDS (laptop PC)
1. Select "DataLogger".
2. Select "Modules".
3. Select "ABS".
When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "ABS".
3. Select "DataLogger".
3. Select the active command modes from the PID table.
Fig. 5: Identifying DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
4. Perform the active command modes, inspect the operations for each parts.
If the operation of output parts cannot be verified after the active command mode inspection is
performed, this could indicate the possibility of an open or short circuit, sticking, or operation
malfunction in the output parts.
DTC TABLE
DTC CHART
2008 Mazda CX-9 Grand Touring
2008 BRAKES On-Board Diagnostic (DSC/RSC) - Mazda CX-9
value of input/output signals in the module. Therefore, if the
monitored value of the output parts is not within the specification, it
is necessary to inspect the monitored value of input parts
corresponding to the applicable output part control. In addition,
because the system does not display an output part malfunction as
an abnormality in the monitored value, it is necessary to inspect the
output parts individually.