Mazda CX-9 Grand Touring 2009 Manual page 46

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
2
for 1 min or more.
Disconnect the passenger-side side air bag
module connector. (See SIDE AIR BAG
MODULE REMOVAL/INSTALLATION .)
Is there any malfunction of the passenger-side
side air bag module connector?
VERIFY WHETHER MALFUNCTION IS IN
PASSENGER-SIDE SIDE AIR BAG MODULE
OR RELATED WIRING HARNESS
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm resistance
to passenger-side side air bag module connector
terminals A and B.
3
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Are DTCs B1055, B1996, B1997, B1998 and/or
B1999 indicated?
INSPECT WIRING HARNESS BETWEEN
PASSENGER-SIDE SIDE AIR BAG MODULE
AND SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
Remove the glove compartment. (See GLOVE
COMPARTMENT
REMOVAL/INSTALLATION .)
Disconnect the passenger-side air bag module
2008 Mazda CX-9 Grand Touring
No Go to the next step.
Yes Go to the next step.
Replace the passenger-side side air bag
module.
No
(See SIDE AIR BAG SENSOR NO.
1 REMOVAL/INSTALLATION .)
Replace the SAS control module. (See