Mazda CX-9 Grand Touring 2009 Manual page 79

Connect the seat weight sensor control
module connector.
Connect the SAS control module.
Connect the negative battery cable.
Verify the following PIDs using the
M-MDS. (See PID/DATA
MONITOR TABLE.)
OCSFLT_CAL
4
OCSFLT_COM
OCSFLT_L
OCSFLT_MDL
OCSFLT_R
Do all PIDs display "OK"?
INSPECT SAS CONTROL MODULE
5
Reperform the DTC inspection.
Is DTC B2290 indicated?
DTC B2477
DTC B2477 DETECTION CONDITION AND POSSIBLE CAUSE
DTC B2477 Configuration error
WARNING:
DETECTION
CONDITION
POSSIBLE
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an inspection according to only the
detection conditions may cause injury due to an operating error, or damage
the system. When performing an inspection, always follow the inspection
procedure.
SAS control module configuration has not been performed correctly.
SAS control module configuration error
Perform seat weight sensor
calibration (See SEAT WEIGHT
SENSOR CALIBRATION .)
If OCSFLT_COM or OCSFLT_MDL is
Seat weight sensor control module
(See SEAT WEIGHT SENSOR
CONTROL MODULE
REMOVAL/INSTALLATION .)
No
If OCSFLT_L is displayed:
Seat weight sensor (LH) (See: 09-
DISASSEMBLY/ASSEMBLY.)
If OCSFLT_R is displayed:
Seat weight sensor (RH) (See
DISASSEMBLY/ASSEMBLY .)
[Present malfunction diagnosis]
Replace the SAS control module.
(See SAS CONTROL MODULE
Yes REMOVAL/INSTALLATION .)
[Past malfunction diagnosis]
DTC troubleshooting completed.
No DTC troubleshooting completed.
displayed:
13-3 FRONT SEAT
FRONT SEAT