Mazda CX-9 Grand Touring 2009 Manual page 107

Fig. 17: Identifying Curtain Air Bag Module & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
5. Install in the reverse order of removal.
CAUTION:
6. When the ignition switch is turned to the ON position verify that the air bag system warning light
illuminates for approx. 6 s and goes out .
If the air bag system warning light does not operate normally, refer to the on-board diagnostic
system (air bag system) and perform inspection of the system. (See FLOWCHART .)
CRASH ZONE SENSOR REMOVAL/INSTALLATION
WARNING:
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more .
3. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9
After installing the curtain air bags, verify that the connector
and wiring harness are not caught.
Handling the crash zone sensor improperly can accidentally deploy
the air bags and pre-tensioner seat belts, which may seriously injure
you. Read the air bag system service warnings and cautions before
handling the crash zone sensor. (See AIR BAG SYSTEM SERVICE
WARNINGS.) (See AIR BAG SYSTEM SERVICE CAUTIONS.)