Mazda CX-9 Grand Touring 2009 Manual page 44

Inspect the wiring harness between SAS control
module terminal 2J and driver-side pre-tensioner
seat belt terminal A, SAS control module
terminal 2N and driver-side pre-tensioner seat
belt terminal B for the following:
Short to ground
Short to power supply
Open circuit
Is the wiring harness normal?
DTC B1055, B1996, B1997, B1998, B1999
DTC B1055, B1996, B1997, B1998, B1999 DETECTION CONDITION AND POSSIBLE CAUSE
B1055 Passenger-side side air bag module and other air bag module circuits short
B1996 Passenger-side side air bag module circuit short to power supply
DTC B1997 Passenger-side side air bag module circuit short to body ground
B1998 Passenger-side side air bag module circuit resistance high
B1999 Passenger-side side air bag module circuit resistance low
WARNING:
DETECTION
CONDITION
POSSIBLE
CAUSE
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Detection conditions are for understanding the DTC outline before performing an
inspection. Performing an inspection according to only the detection conditions
may cause injury due to an operating error, or damage the system. When
performing an inspection, always follow the inspection procedure.
Resistance other than 1.0-9.7 ohms detected in passenger-side side air bag module
circuit
Malfunction in wiring harness between passenger-side side air bag module and SAS
control module
Open or short circuit in wiring harness between passenger-side side air bag module
Passenger-side side air bag module malfunction
No Replace the air bag wiring harness.
and SAS control module
SAS control module malfunction