Mazda CX-9 Grand Touring 2009 Manual page 42

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Using the M-MDS, verify the following
PID/DATA monitor.
(See PID/DATA MONITOR TABLE.)
1
RES_PT_D
Is the resistance of the driver-side pre-tensioner
seat belt normal?
Resistance: 1.0-9.7 ohms
INSPECT DRIVER-SIDE PRE-TENSIONER
SEAT BELT CONNECTOR
WARNING:
Handling the air bag system components
improperly can accidentally deploy the air
bag modules and pre-tensioner seat belts,
which may seriously injure you. Read the
service warnings and cautions before
handling the air bag system components.
(See AIR BAG SYSTEM SERVICE
WARNINGS .)
(See AIR BAG SYSTEM SERVICE
2
CAUTIONS .)
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Remove the B-pillar lower trim (LH). (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
Disconnect the driver-side pre-tensioner seat
belt connector. (See FRONT SEAT BELT
REMOVAL/INSTALLATION .)
Is there any malfunction of the driver-side pre-
tensioner seat belt connector?
VERIFY WHETHER MALFUNCTION IS IN
DRIVER-SIDE PRE-TENSIONER SEAT BELT
OR RELATED WIRING HARNESS
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm resistance
to driver-side pre-tensioner seat belt connector
2008 Mazda CX-9 Grand Touring
Replace the SAS control module. (See
Yes SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
No Go to the next step.
Yes Replace the air bag wiring harness.
No Go to the next step.
Yes Go to the next step.