1. Verify that the continuity between the PLG rear switch terminals is as indicated in the table.
If not as indicated in the table, replace the PLG rear switch.
Fig. 26: PLG Rear Switch Continuity Chart
Courtesy of MAZDA MOTORS CORP.
Fig. 27: PLG Rear Switch - Circuit Diagram
Courtesy of MAZDA MOTORS CORP.
2. Apply battery voltage to PLG rear switch terminal A, and connect terminal B to ground.
3. Verify that the LED illuminates.
If there is any malfunction, replace the PLG rear switch.
POWER LIFTGATE (PLG) BUZZER REMOVAL/INSTALLATION
CAUTION:
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION .)
2. PLG arm (See POWER LIFTGATE (PLG) DRIVE UNIT REMOVAL/INSTALLATION.)
3. Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION .)
4. Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION .)
3. Disconnect the PLG buzzer connector.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Doors and Liftgate - Mazda CX-9
Do not remove the PLG buzzer except when replacing the PLG buzzer
because thread-locking compound has been applied to the screws.