Mazda CX-9 Grand Touring 2009 Manual page 668

2. Remove the bolts.
3. Pull the joint shaft straight out.
CAUTION:
CLIP INSTALLATION NOTE
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip
does not exceed the specification on installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat Step 1 using a new
clip.
Clip outer diameter specification 34.0 mm {1.34 in} max.
Fig. 27: Identifying Clip Outer Diameter
Courtesy of MAZDA MOTORS CORP.
JOINT SHAFT REMOVAL/INSTALLATION [AWD]
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
The sharp edges of the joint shaft can slice or puncture the oil
seal. Be careful when removing the joint shaft from the
transaxle.
Fig. 26: Separating Right Side Drive Shaft
Courtesy of MAZDA MOTORS CORP.