Mazda CX-9 Grand Touring 2009 Manual page 102

4. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
5. Center panel (See CENTER PANEL REMOVAL/INSTALLATION .)
6. Front scuff plate inner (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
7. Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
8. Dashboard under cover (Passenger side) (See DASHBOARD UNDER COVER
REMOVAL/INSTALLATION .)
9. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
10. Side panel (See SIDE PANEL REMOVAL/INSTALLATION .)
11. Dashboard garnish (See DASHBOARD GARNISH REMOVAL/INSTALLATION .)
12. HF/TEL unit (See HANDS-FREE TELEPHONE (HF/TEL) UNIT
REMOVAL/INSTALLATION .) (vehicles with HF/TEL system)
4. Remove the bolts.
5. Remove the screws.
6. Remove the clips.
7. Remove the connector.
8. Remove the passenger-side air bag module in the direction of the arrow
9. Install in the reverse order of removal.
10. Turn the ignition switch to the ON position.
11. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
If the air bag system warning light does not operate normally, refer to the on-board diagnostic
system (air bag system) and perform inspection of the system. (See FLOWCHART .)
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9