Mazda CX-9 Grand Touring 2009 Manual page 299

2005-08 TRANSMISSION Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6
Fig. 248: Identifying Sun Gear Input Drum Of Transaxle Case
Courtesy of MAZDA MOTORS CORP.
41. Apply ATF to the bearing race and the thrust bearing, and then install them to the transaxle case.
42. Install the C1 clutch component to the transaxle case.
Fig. 249: Identifying C1 Clutch Component Of Transaxle Case
Courtesy of MAZDA MOTORS CORP.
43. Apply ATF to the bearing race and the thrust bearing, and then install them to the transaxle case.
CAUTION:
NOTE:
44. Install the input shaft and the front planetary gear to the transaxle case.
2008 Mazda CX-9 Grand Touring
If the input shaft is not hold during installation, the thrust
washer might be come off.
Align the spline of the C1 clutch drive plates before installing the
input shaft and front planetary gear.
Hold the C1 clutch component and install the front planetary gear
while holding the input shaft.