Mazda CX-9 Grand Touring 2009 Manual page 723

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
BRAKE FLUID PRESSURE SENSOR INSPECTION
NOTE:
The brake fluid pressure sensor is integrated into the DSC HU/CM and
installed to the brake line of RF- LR brake system. Therefore, perform the
brake fluid pressure sensor inspection with the SST installed to the brake
pipe on the left front wheel.
1. Turn the ignition switch off.
2. Disconnect the brake pipe flare nut area using a commercially available flare nut wrench.
3. Remove the clamp and disconnect the brake hose.
Fig. 33: Identifying Brake Pipe, Brake Hose & Clamp
Courtesy of MAZDA MOTORS CORP.
4. Install the SSTs to the brake pipe as shown in the figure.
5. Bleed the brake line and the SSTs of air. Bleed the air from the SSTs using bleeder screw A.
Fig. 34: Identifying Brake Pipe With SST
Courtesy of MAZDA MOTORS CORP.
6. Connect the M-MDS to the DLC-2.
7. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
When using the IDS (laptop PC)
2008 Mazda CX-9 Grand Touring