2005-08 TRANSMISSION Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6
Fig. 156: Measuring Starting And Rotating Torque Of Counter Drive Gear
Courtesy of MAZDA MOTORS CORP.
COUNTER DRIVE GEAR STARTING AND ROTATING TORQUE
Bearing
New 0.40 - 0.50 {4.08 - 5.09, 3.55 - 4.41} 0.40 - 0.48 {4.08 - 4.89, 3.55 - 4.24}
Reused 0.20 - 0.25 {2.04 - 2.54, 1.77 - 2.20} 0.20 - 0.24 {2.04 - 2.44, 1.77 - 2.11}
Adjust the starting and rotating torque by tightening the nut.
If the starting and rotating torque does not fall within the specification, loosen the nut and retighten
the nut to adjust torque.
9. Using a flathead screwdriver and hammer, crimp down the washer.
Fig. 157: Crimping Down Washer
Courtesy of MAZDA MOTORS CORP.
10. Using a flathead screwdriver, install the hole snap ring to the counter drive gear.
11. Install the rear planetary ring gear flange to the rear planetary ring gear.
2008 Mazda CX-9 Grand Touring
Starting torque
N.m {kgf.cm, in.lbf}
Rotating torque