Fig. 15: Prying Outer Ring
Courtesy of MAZDA MOTORS CORP.
SNAP RING, TRIPOD JOINT DISASSEMBLY NOTE
1. Mark the shaft and tripod joint for proper assembly.
2. Remove the snap ring using snap-ring pliers.
3. Remove the tripod joint from the shaft.
CAUTION:
BOOT DISASSEMBLY NOTE
NOTE:
The wheel side boot does not need to be removed unless replacing it or
the ball joint and shaft component.
Do not strip the tape until the boot is assembled.
1. Wrap the shaft splines with tape.
2. Remove the boot.
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
Do not tap the tripod joint with a hammer.
Fig. 16: Removing Snap Ring With Snap-Ring Pliers
Courtesy of MAZDA MOTORS CORP.