Mazda CX-9 Grand Touring 2009 Manual page 27

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm resistance
to passenger-side air bag module (inflator No.1)
connector terminals 1A and 1B, and passenger-
side air bag module (inflator No.2) connector
terminals 2A and 2B.
3
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Are DTCs B1048, B1925, B1933, B1935 and/or
B1938 indicated?
INSPECT WIRING HARNESS BETWEEN
PASSENGER-SIDE AIR BAG MODULE AND
SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more .
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side front
seat connectors. (See FRONT SEAT
REMOVAL/INSTALLATION .)
4
Disconnect the driver and passenger-side curtain
air bag module connectors. (See CURTAIN
AIR BAG MODULE
REMOVAL/INSTALLATION .)
Remove the B-pillar lower trim. (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See FRONT
SEAT BELT
REMOVAL/INSTALLATION .)
Disconnect the SAS control module connectors.
(See SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
Inspect the wiring harness between SAS control
module terminal 1J and passenger-side air bag
2008 Mazda CX-9 Grand Touring
Replace the passenger-side air bag
module.
No (See PASSENGER-SIDE AIR BAG
MODULE
REMOVAL/INSTALLATION .)
Replace the SAS control module. (See
Yes SAS CONTROL MODULE
REMOVAL/INSTALLATION .)