Mazda CX-9 Grand Touring 2009 Manual page 36

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
WARNINGS .)
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
1
Remove the B-pillar lower trim (RH). (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
Disconnect the passenger-side side air bag
sensor No.1 connector. (See SIDE AIR BAG
SENSOR NO. 1
REMOVAL/INSTALLATION .)
Is there any malfunction of the passenger-side
side air bag sensor No.1 connector?
INSPECT WIRING HARNESS BETWEEN
PASSENGER-SIDE SIDE AIR BAG SENSOR
NO.1 AND SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
Remove the glove compartment. (See GLOVE
2
COMPARTMENT
REMOVAL/INSTALLATION .)
Disconnect the passenger-side air bag module
connector. (See PASSENGER-SIDE AIR
BAG MODULE
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side front
seat connectors. (See FRONT SEAT
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side curtain
air bag module connectors. (See CURTAIN
AIR BAG MODULE
REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
No Go to the next step.
Replace the passenger-side side air bag
sensor No.1, then go to the next step.
Yes
(See SIDE AIR BAG SENSOR NO.
1 REMOVAL/INSTALLATION .)