Mazda CX-9 Grand Touring 2009 Manual page 706

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
1. Select "Chassis".
2. Select "ABS/DSC".
3. Select "Sensor Initialization".
When using the PDS (Pocket PC)
1. Select "Module Test".
2. Select "ABS".
3. Select "Datalogger".
4. Select "SSR_INTL".
6. Perform the initialization according to the directions on the screen.
Fig. 14: Connecting M-MDS To DLC-2
Courtesy of MAZDA MOTORS CORP.
DSC/RSC HU/CM INSPECTION
1. Disconnect the DSC/RSC HU/CM connector. (See DSC/RSC HU/CM
REMOVAL/INSTALLATION.)
2. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7] .)
3. Attach the tester lead to the DSC/RSC HU/CM harness side connector, then inspect voltage, continuity or
resistance according to the standard (reference value) on the table.
STANDARD (REFERENCE VALUE)
2008 Mazda CX-9 Grand Touring