Mazda CX-9 Grand Touring 2009 Manual page 358

2008 TRANSMISSION Automatic Transaxle (AW6A-EL, AW6AX-EL) - Mazda CX-9
Fig. 31: Identifying Coupler Component Connector Terminal
Courtesy of MAZDA MOTORS CORP.
OFF-VEHICLE INSPECTION
WARNING:
CAUTION:
1. Disconnect the negative battery cable.
2. Remove the VSS. (See VEHICLE SPEED SENSOR (VSS) REMOVAL/INSTALLATION [AW6A-
EL, AW6AX-EL].)
3. Connect the VSS terminal 2 to the battery positive terminal, connect the battery negative terminal to VSS
terminal 1 through an ammeter set to a resistance of 100 ohm.
Fig. 32: Connecting VSS Terminal 2 To Battery Positive Terminal
2008 Mazda CX-9 Grand Touring
A hot transaxle and ATF can cause severe burns. Turn off the engine
and wait until they are cool before replacing the ATF.
Water or foreign material entering the connector can cause a poor
connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
Do not damage the terminals.