Mazda CX-9 Grand Touring 2009 Manual page 638

1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
2. Seat side box (LH) (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
5. Third-row seat belt lower anchor installation bolt (LH) (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
6. Rear scuff plate inner (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
7. Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
8. Roof side trim (LH) (See ROOF SIDE TRIM REMOVAL/INSTALLATION .)
9. Second-row seat belt upper anchor installation bolt (LH) (See SECOND-ROW SEAT BELT
REMOVAL/INSTALLATION .)
10. C-pillar trim (LH) (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
11. Third-row seat belt upper anchor installation bolt (LH) (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
12. D-pillar trim (LH) (See D-PILLAR TRIM REMOVAL/INSTALLATION .)
3. Disconnect the PLG arm band with using the flat blade screwdriver.
4. Remove the PLG arm.
5. Install in the reverse order of removal.
Fig. 13: Prying PLG Arm Band With Screwdriver
Courtesy of MAZDA MOTORS CORP.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Doors and Liftgate - Mazda CX-9