Mazda CX-9 Grand Touring 2009 Manual page 23

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
RES_SAB_D
Is the resistance of the driver-side side air bag
module normal?
Resistance: 1.0-9.7 ohms
INSPECT DRIVER-SIDE SIDE AIR BAG
MODULE CONNECTOR
WARNING:
Handling the air bag system components
improperly can accidentally deploy the air
bag modules and pre-tensioner seat belts,
which may seriously injure you. Read the
service warnings and cautions before
handling the air bag system components.
(See AIR BAG SYSTEM SERVICE
WARNINGS .)
2
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more .
Disconnect the driver-side side air bag module
connector. (See SIDE AIR BAG MODULE
REMOVAL/INSTALLATION .)
Is there any malfunction of the driver-side side
air bag module connector?
VERIFY WHETHER MALFUNCTION IS IN
DRIVER-SIDE SIDE AIR BAG MODULE OR
RELATED WIRING HARNESS
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm
resistance to driver-side side air bag module
3 connector terminals A and B.
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
Connect the negative battery cable.
Turn the ignition switch to the ON position.
Are DTCs B1047, B1992, B1993, B1994,
and/or B1995 indicated?
2008 Mazda CX-9 Grand Touring
No Go to the next step.
Yes Replace the air bag wiring harness.
No Go to the next step.
Yes Go to the next step.
Replace the driver-side side air bag
module. (See SIDE AIR BAG
No
MODULE
REMOVAL/INSTALLATION .)