Mazda CX-9 Grand Touring 2009 Manual page 683

REAR DRIVE SHAFT REMOVAL NOTE
1. Disengage the rear drive shaft using the SSTs.
NOTE:
CLIP INSTALLATION NOTE
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip
does not exceed the specification on installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat Steps 1-2 using a new
clip.
Clip outer diameter specification 29.5 mm {1.16 in} max.
Fig. 50: Identifying Clip Outer Diameter
Courtesy of MAZDA MOTORS CORP.
REAR DRIVE SHAFT DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
Be careful not to damage the rear differential oil seal.
Fig. 49: Disengaging Rear Drive Shaft With SST
Courtesy of MAZDA MOTORS CORP.